Equicom PING3-PWR2

PING3-PWR2 is the multi-function printer which basic function is remote control two independent sockets of a power supply 220B  on an Ethernet network. The maximum power of loading on each channel 1100BA.  besides, the device can be used for serviceability check of Ethernet segments of networks and also for protection, remote monitoring and management of different objects without direct presence of the person (as the device of "remote presence"). 

Learn more about EQUICOM PING3-PWR2 (the Smart Socket)>>>

As well as all devices of PING3 series, they have the following main features:

Connection of two-level sensors: opening of a door, breaking glass, movement, fire warning

Control of analog parameters: tension, temperature, etc.

Ping-control of availability of the set IP addresses, autonomous reset of the equipment in case of lack of communication

Remote monitoring and management via the WEB interface, Telnet, SNMP v1, v2c 

Sending SNMP of ladders with a possibility of confirmation at approach of different events

Remote update of the software (firmware)

Hardware features.

3 control links power supply of external devices channels 1 and 2 are sockets 220B, 1100 BA channel 3 is an exit of LVTTL of level 5 digital lines of I/O (4-TTL, 1-LVTTL level), each of which can be independently programmed on input or on an output. Two-level sensors can be connected to input lines: opening of a door, breaking glass, movement, fire warning. Output lines can be used for management of different loadings by means of external schemes of approval.

3 analog inputs (10-bit ATsP) to which it is possible to connect temperature sensors, humidity, etc.

Input of Power Sensor (TTL level) allowing to control presence of tension in network of power supply at connection to it of the external sensor of existence of network 220B

EXT expansion connector for connection of the additional hardware Port 10Base-T Half duplex

LED indication of inclusion in network, acceptances/transfers of packets and inclusion of a power supply in channels 1 and 2

The timer which is built in by Watchdog

Program opportunities.

The configured static IP address, the MAC address, subnet mask, the gateway

Bilateral data exchange on an Ethernet network, support of the ARP protocol

Remote monitoring and management via the WEB interface, Telnet, SNMP v1, v2c

Answer to ICMP requests (Ping) support of fragmentation of packets the maximum length of a packet is 5912 bytes

Sending ICMP of requests (Ping) support of fragmentation of packets the maximum length of a packet is 65535 bytes observation in real time of percent of losses of packets and response time Different operation modes of control link power supply Ping mode is control of availability to 3 IP addresses and interruption of a power supply of load of the set interval at communication loss (a task of different logic functions for the analysis of answers from each IP address, flexible configuration of parameters of the sent ICMP of packets for each address). The mode is used for autonomous reset of the "hung-up" active network equipment. Reset of the equipment manually is also possible.

Analog mode is power management of loading depending on tension on an analog input (above or below border, or stay in the range of values)

The manual mode – independent load control in each channel at the command of the operator

Function of a security alarm – inclusion of a power supply in channel 1 at operation at least one of two two-level sensors (only in firmware with the index "a" after version number)

Sending SNMP of ladders of v2c with a possibility of confirmation to four set addresses at approach of any events connected with functioning of the device: state change of external sensors, voltage variation on an analog input, state change of control link a power supply, etc.

Two accounts of users with a possibility of change of the password Admin is full control over all functions User is only observation of a device status

Restriction of administrative access (2 permitted ranges of the IP addresses)

Remote update of the software (firmware)

Reset of all settings to starting values by means of the Reset button, or far off through a user interface

Preserving of all settings in the file of a configuration and the subsequent loading from the file

Website: www.equicom.ru